Request for Quote

Please fill in the form below to receive a prompt quote.


W-Technologies Hydraulic Shock Dampers

Hydraulic shock dampers are beneficial in any blanking, punching or die trimming application that is experiencing load reversal shock such as:

W-Technologies hydraulic shock dampers include the following features:

  • Portable
  • North American components
  • Stock and custom sizes available
  • Successful in hydraulic and mechanical presses
  • Cost effective

Our standard damper is designed with 2,600 psi internal pressure capacity (U Series) or with 5,000 psi internal pressure capacity (H Series). Individual cylinder capacity will range from 6 tons to over 550 tons. Contact our office or any representative for the recommended cylinder size for your application.

We back our products with a 100% customer satisfaction guarantee. If the hydraulic dampers do not meet the customer satisfaction, all financial obligation is cancelled and returned.


Largest Dampers Ever Made

W-Technologies Custom Hydraulic Shock Dampers built two of the largest dampers ever made, U1000 dampers.

Manufactured in 1998, the seals were initially replaced ten years later, in 2008. Just recently, in 2019, both dampers were sent back to the plant to replace the seals for a second time, rendering a “like-new” damper for a fraction of the cost of a new damper.

The largest dampers ever made are Built to Last!

Image showing the hieght of our hydraulic damper
Made in USA W-Technologies Hydraulic Shock Dampers

Customer Testimonial

"Three things were promoted to me by W-Technologies: reduction in noise, shock (vibration) and extended tool life. Since our purchase the dampers are working fine. Temperature is good, shock and noise reduced. Getting an 175,000 to 225,000* hits before needing to sharpen."

David Curler,
Tooling Manager

*150,000 hits between sharpening prior to installation.